Front Page - axing MIP 8-00 Betriebsanleitung

Operation instructions | MIP 8-00 | MIP 16-00 | MIP 8-06 | MIP 16-06
3.2.

Front page

The relevant information required for the function of the system are shown on the front page. The decisive thing is the quality
of the signals at the INPUT and the utilization of the OUTPUT.
Input
The bit error rate BER of all four tuners is shown on the left side. The amount of bit errors for the last 1,000,000 transferred
bits is calculated. Also the Level and the C/N ratio are shown.
Outputs
The fill level of the output is shown.
Note: The figure shows the start page of a device that outputs the output signals as MPTS (Multi Program Transport Stream).
Here, the levels of the outputs ( Output 1 to Output 8/16) are shown separately. For a device that provides the output signals
as SPTS (Single Program Transport Stream), only the total fill level of IPTV is displayed on the start page.
If the current fill level exceeds the maximal fill level, it may cause image disturbances, e.g. mosaic images. From a fill level of
95%, this is indicated in red.
Recommendation: As the data rate of the transmitters can vary depending on the picture content and transmission quality, it
is essential to keep a reserve. We recommend a maximum fill level of 90% to ensure interference-free reception.
Page 14 of 48 BA_MIP-8-16-0x.pdf | Technical improvements, changes in design, printing- and other errors reserved. | 2022-02-03