Decommissioning; Decommissioning The Device; Transport; Transporting The Device - Sartorius Entris II Essential Line BCE224 Betriebsanleitung

11

Decommissioning

11.1

Decommissioning the Device

Procedure
Switch off the device.
t
Disconnect the device from the power supply.
t
Disconnect the device from all connected devices
t
and all accessories, e.g. printer.
Clean the device (see Chapter 9.2, page 37).
t

12 Transport

12.1

Transporting the Device

Procedure
CAUTION Risk of injury from breaking glass! Glass
t
components can break if they fall or are handled
incorrectly. Glass fragments can cause cuts.
Only lift the device by its base, not by the draft
t
shield.
When lifting and transporting, ensure that no per-
t
sonnel or objects are in the way.
Use suitable conveyance devices for long transport
t
routes.

13 Storage and Shipping

13.1

Storage

Procedure
Switch off the device.
t
Disconnect the device from the power supply.
t
Disconnect the device from all connected devices,
t
e.g. printer.
Store the device according to the ambient conditions
t
(see Chapter 15.1, page 42).

13.2 Returning the Device and Parts

Defective devices or parts can be sent back to Sartorius.
Returned devices must be clean, decontaminated, and
packed correctly, e.g. in their original packaging.
Transport damage as well as measures for subsequent
cleaning and disinfection of the device or parts by
Sartorius shall be charged to sender.
WARNING
Risk of injury due to contaminated devices .
Devices contaminated with hazardous materials
(nuclear, biological, or chemical – NBC) will not be
accepted for repair or disposal.
Observe the information on decontamination (see
t
Chapter 14.1, page 41).
Procedure
Switch off the device.
t
Disconnect the device from the power supply.
t
Contact Sartorius Service for instructions on how to
t
return devices or parts (please refer to our website at
www.sartorius.com for return instructions).
Pack the device and its parts properly for return, e.g.
t
in their original packaging.

14 Disposal

14.1 Information on
Decontamination
The device does not contain any hazardous materials
that would necessitate special disposal actions.
Contaminated samples used during the process are
potentially hazardous materials that could cause biolog-
ical or chemical hazards.
If the device has come into contact with hazardous sub-
stances: Steps must be taken to ensure proper decon-
tamination and declaration. The operator is responsible
for adhering to local government regulations on the
proper declaration for transport and disposal and the
proper disposal of the device.
WARNING
Risk of injury due to contaminated devices .
Devices contaminated with hazardous materials (NBC
contamination) will not be accepted by Sartorius for
repair or disposal.
Entris BCE Operating Instructions
®
Decommissioning
41