Installation; Scope Of Delivery; Selecting An Installation Site; Unpacking - Sartorius Entris II Essential Line BCE224 Betriebsanleitung

5

Installation

5.1

Scope of Delivery

Item
Device
Weighing pan
Pan support
Power supply unit with country-specific
adapters
Draft shield
For models with analytical draft shield:
Dust cover
Operating instructions
5.2

Selecting an Installation Site

Procedure
Ensure that the following conditions are met at the
t
installation site:
Condition Characteristics
Ambient condi- — Suitability tested (for ambient
tions conditions, see Chapter 15.7,
page 44)
Setup surface — Stable, even surface with little
vibration
— Sufficient space for the device
(for space requirements, see
Kapitel „15.9 Device Dimensi-
ons", Seite 46)
— Sufficient load bearing capaci-
ty for the device (for device
weight, see Chapter 15.10,
page 47)
Access to parts Convenient and safe
relevant to
operation
5.3
Procedure
Unpack the device.
t
CAUTION Glass breakage due to the incorrect
t
handling of the device! Do not lift the device by the
Quantity
draft shield. Only lift the device by its base.
Install the device at the intended installation site.
1
t
If the device is stored temporarily: Observe the stora-
t
1
ge information (see Chapter 13.1, page 41).
1 Keep all parts of the original packaging, e.g. to return
t
the device.
1
1
5.4
1
1
5.4.1
Procedure

Unpacking

Installing the Weighing Pan
and Associated Components

Installing a Device with Analytical

Draft Shield
Fully open the side
t
panel of the analyti-
cal draft shield.
Fit the pan support
t
on the pan retainer
and place the weigh-
ing pan on top.
Entris BCE Operating Instructions
®
Installation
17