Turbo Brush - hanseatic VC-T4020E-1 Gebrauchsanleitung

Page EN-12 Appliance parts
The vacuum cleaner comes with
various nozzles designed for a
range of uses. Where required,
before or during vacuuming, each
nozzle can be attached to the tel-
escopic suction hose (16) or the
telescopic tube (17).
Universal floor nozzle
(18)
You will work with the universal
floor nozzle (18) most of the time,
as it is designed for large, flat sur-
faces.
The best vacuuming results are
achieved when you adapt the ap-
pliance to the floor surface using
the foot selector switch (24).
– For short-pile or smooth floors
such as needle felt, PVC, par-
quet or tiles:
Set the foot selector switch (24)
to the correct position
– For long-pile rugs/carpets:
Set the foot selector switch (24)
to the correct position
The foot selector switch (24) can
also be readjusted during opera-
tion.
Depending on the floor covering
and amount of dirt, you can adjust
the suction force using the On-Off
foot switch/suction force control
unit (10) (see section "Setting the
suction force" on page EN-17).

Turbo brush

(24)
The rotating turbo brush (19) is
propelled by the vacuum air flow.
It is particularly suitable for vacu-
uming hair and thread from rugs
and carpeted floors. When using
the turbo brush, set the vacuum
cleaner to the maximum suction
force (see section "Setting the
suction force" on page EN-17).
.
.
(19)