Risks In Handling Household Electrical Appliances - hanseatic HBCO7010PA1 Gebrauchsanleitung

■ Do not allow children to play with the
appliance or have access to the appli-
ance if they are unsupervised.
■ Cleaning and user maintenance must
not be carried out by children unless
they are supervised.
■ The appliance and its accessible parts
become hot during use. You must
take care to avoid touching the heat-
ing elements. Children aged 8 years
or younger must be kept away from
the device, unless they are under con-
stant supervision.
Risks in handling household
electrical appliances
WARNING
Risk of electric shock!
Touching live parts may result in severe
injury or death.
■ Only use the appliance indoors. Do
not use in wet rooms or in the rain.
■ Do not operate or continue to oper-
ate the appliance if it
– shows visible signs of damage, for
example, the connection cable
is defective, the control panel is
cracked or the door does not close
tightly:
– starts smoking or there is a burning
smell;
– makes unusual sounds.
In such cases, remove the mains plug
and contact our Service department
(see page EN-40).
■ The appliance corresponds to protec-
tion class 1 and may only be connect-
ed to a properly installed protective
conductor. Ensure that the voltage is
correct when connecting it. More de-
Safety
tailed information about this can be
found on the nameplate.
■ Connection to the mains supply may
only be made by an authorised elec-
trician approved by the local energy
supply company (see page EN-40).
Only then will you benefi t from our
warranty and a suffi cient level of
safety. Unauthorised persons may
not connect the appliance to the
mains supply. You can endanger
your life and that of subsequent us-
ers! This also applies to disconnection
from the power supply and disman-
tling the old appliance.
■ Since all poles of the appliance can-
not be disconnected from the mains
via an accessible disconnecting de-
vice, an all-pole disconnecting device
in accordance with overvoltage cate-
gory III must be connected within the
house installation with at least 3 mm
contact clearance; consult a qualified
professional if necessary (see page
EN-40).
■ If the mains plug is no longer acces-
sible after installation, an all-pole dis-
connecting device complying with
overvoltage category III must be
connected to the house wiring with a
contact gap of at least 3 mm; consult
a qualifi ed professional if necessary
(see page EN-40).
■ Before connecting the device, switch
off the relevant electric circuit(s)
(switch off circuit breakers or un-
screw fuses). Before accessing the
terminals, all supply circuits must be
switched off.
Page EN-5