Assembly; Operation - Husqvarna 120i Bedienungsanweisung

• Only use the guide bar/saw chain combinations and
filing equipment that we recommend. Refer to
Accessories on page 37 for instructions.
• Use protective gloves when you use or do
maintenance on the saw chain. A saw chain that
does not move can also cause injuries.
• Keep the cutting teeth correctly sharpened. Obey the
instructions and use the recommended file gauge. A
saw chain that is damaged or incorrectly sharpened
increases the risk of accidents.(Fig. 43)
• Keep the correct depth gauge setting. Obey the
instructions and use the recommended depth gauge
setting. Too large depth gauge setting increases the
risk of kickback.(Fig. 44)
Introduction
WARNING:
safety chapter before you assemble the
product.
To assemble the guide bar and saw
chain
WARNING:
before you assemble or do maintenance on
the product.
1. Disengage the chain brake. (Fig. 47)
2. Loosen the knob and remove the drive sprocket
cover (chain brake) and the transportation guard (A).
(Fig. 48)
3. Put the guide bar on top of the bar bolt. Steer the
guide bar to its most rear position. Lift the saw chain
above the drive sprocket and engage it in the groove
on the guide bar. Start on the top edge of the guide
bar. (Fig. 49)
Introduction
WARNING:
safety chapter before you use the product.
To do a function check before you use
the product
1. Do a check of the chain brake (A) to make sure that
it operates correctly and that it is not damaged.
2. Do a check of the rear right hand guard (B) to make
sure that it is not damaged.
1259 - 003 - 14.09.2020

Assembly

Read and understand the
Always remove the battery

Operation

Read and understand the
• Make sure that the saw chain has the correct
tension. If the saw chain is not tight against the guide
bar, the saw chain can derail. An incorrect saw chain
tension increases wear on the guide bar, saw chain
and chain drive sprocket. Refer to
chain on page 33 .(Fig. 45)
• Do maintenance on the cutting equipment regularly
and keep it correctly lubricated. If the saw chain is
not correctly lubricated, the risk of wear on the guide
bar, saw chain and chain drive sprocket increases.
(Fig. 46)
4. Make sure that the edges of the cutting links face
forward on the top edge of the guide bar.
5. Assemble the drive sprocket cover and steer the
chain adjuster pin to the hole in the guide bar.
6. Make sure that the drive links of the saw chain fit
correctly on the drive sprocket.
7. Make sure that the saw chain is correctly engaged in
the groove in the guide bar.
8. Tighten the saw chain. See
on page 33 for instructions.
To assemble a spiked bumper
To assemble a spiked bumper, speak to your servicing
dealer.
3. Do a check of the power trigger and the power
trigger lockout (C) to make sure that they operate
correctly and that they are not damaged.
4. Do a check of the keypad (D) to make sure that it
operates correctly.
5. Make sure that there is no oil on the handles (E).
6. Do a check to make sure that all parts are correctly
attached and not damaged or missing.
7. Do a check of the chain catcher (F) to make sure
that it is attached correctly.
8. Do a check of the chain tension (G).
9. Charge the battery (H) and make sure that it is
correctly attached to the product.
To tighten the saw
To tighten the saw chain
25