Husqvarna 120i Bedienungsanweisung Seite 27

To start the product
1. Do a check of the power trigger and power trigger
To do a check of the power trigger
lockout. See
lockout on page 31 .
2. Push the front hand guard forward to engage the
chain brake. (Fig. 38)
3. Put the battery in the battery holder. (Fig. 55)
4. Press on the lower part of the battery until you hear
a click sound.
CAUTION:
move into the battery holder easily, it is
not attached correctly into the battery
holder.
(Fig. 56)
5. Press and hold the start/stop button until the green
LED light comes on. (Fig. 57)
To use the SavE function
This product has a power saving function, SavE. The
SavE function decreases the chain speed and gives the
longest operation time from the battery.
Note:
The SavE function does not decrease the
cutting power of the product.
1. Press the SavE button on the keypad.
2. Make sure that the green LED comes on.
3. Press the SavE button again to disconnect the
function. The green LED goes out. (Fig. 58)
To stop the product
1. Press and hold the start/stop button on the keypad
until the green LED light comes off. (Fig. 57)
2. Pull out the battery and press the battery release
buttons to remove the battery from the battery
holder. (Fig. 59)
WARNING:
you do not use or when you do not have full
vision of the product. This is to prevent
accidental start.
Kickback information
WARNING:
serious injury or death to the operator or
others. To decrease the risk you must know
the causes of kickback and how to prevent
them.
A kickback occurs when the kickback zone of the guide
bar touches an object. A kickback can occur suddenly
1259 - 003 - 14.09.2020
If the battery does not
Remove the battery when
A kickback can cause
and with large force, which throws the product in the
direction of the operator.(Fig. 60)
Kickback always occurs in the cutting plane of the guide
bar. Usually, the product is thrown against the operator
but can also move in a different direction. It is how you
use the product when the kickback occurs that causes
the direction of the movement.(Fig. 61)
Kickback only occurs if the kickback zone of the guide
bar touches an object. Do not let the kickback zone
touch an object.(Fig. 60)
A smaller bar tip radius decreases the force of the
kickback.
Use a low kickback saw chain to decrease the effects of
kickback. Do not let the kickback zone touch an object.
WARNING:
prevents kickback. Always obey the
instructions.
To use the cutting technique
WARNING:
cut and decrease the speed to idle speed
after each cut.
CAUTION:
for too long without load. This can cause
damage to the motor.
1. Put the trunk on a saw horse or runners. (Fig. 62)
WARNING:
pile. That increases the risk of kickback
and can cause serious injury or death.
2. Remove the cut pieces from the work area.
WARNING:
area increase the risk of kickback and
that you cannot keep your balance.
To cut a trunk on the ground
1. Cut through the trunk on the pull stroke. Keep full
power but be prepared for sudden accidents. (Fig.
63)
WARNING:
chain does not touch the ground when
you complete the kerf.
2. Cut approximately ⅔ through the trunk and then
stop. Turn the trunk and cut from the opposite side.
(Fig. 64)
No saw chain fully
Use full power when you
Do not let the motor operate
Do not cut trunks in a
Cut pieces in the work
Make sure that the saw
27