Safety Instructions For Maintenance; Assembly; Operation - Husqvarna 215iHD45 Bedienungsanweisung

• Only charge the battery indoors in a location with
good airflow and away from sunlight. Do not charge
the battery outdoors. Do not charge the battery in
wet conditions.
• Only use the battery charger where the temperature
is between 5 °C (41 °F) and 40 °C (104 °F). Use the
charger in an environment which has a good airflow,
dry and free from dust.
• Do not put objects into the cooling slots of the
battery charger.
• Do not connect the battery charger terminals to
metal objects as this can short circuit the battery
charger.
• Use approved mains sockets that are not damaged.
Make sure that the cord of the battery charger is not
damaged. If extension cables are used, make sure
that the extension cables are not damaged.
• Do not charge non-rechargeable batteries in the
battery chargers.

Safety instructions for maintenance

WARNING:
instructions that follow before you do
maintenance on the product.
Introduction
This section describes how to assemble and adjust the
product.
WARNING:
product, read the safety chapter and the
assembly instructions.
To connect the battery charger
1. Connect the battery charger to the voltage and
frequency that is specified on the rating plate.
2. Put the plug in a grounded socket outlet. The LED
on the battery charger flashes green one time.
Note:
The battery does not charge if the battery
temperature is more than 50 °C/122 °F. If the
temperature is more than 50 °C/122 °F, the battery
Introduction
WARNING:
safety chapter before you use the product.
1710 - 005 - 18.10.2021
Read the warning

Assembly

Before you assemble the

Operation

Read and understand the
• Remove the battery before you do maintenance,
other checks or assemble the product.
• The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
• Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
• If you do not do maintenance, it decreases the life
cycle of the product and increases the risk of
accidents.
• Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
• Only use original spare parts.
charger makes the battery become cool before the
battery charges.
To connect the battery to the product
WARNING:
original batteries in the product.
1. Fully charge the battery.
2. Push the battery into the battery holder of the
product. The battery locks into position when you
hear a click. (Fig. 27)
CAUTION:
move easily into the battery holder, the
battery is not installed correctly. This can
cause damage to the product.
To charge the battery
Note:
Charge the battery if it is the first time that you
use it. A new battery is only 30% charged.
1. Connect the battery to the battery charger. (Fig. 28)
(Fig. 29)
Only use Husqvarna
If the battery does not
11