Front Hand Guard; Keypad; Power Trigger Lockout - Husqvarna 120i Bedienungsanweisung

Maintenance
Do a check of the saw chain. Look for cracks and make sure that the saw chain
is not rigid or unusually worn. Replace if necessary.
Sharpen the saw chain. Do a check of its tension and condition. Do a check for
wear on the drive sprocket and replace is necessary.
Clean the air inlet on the product.
Make sure that the screws and nuts are tight.
Make sure that the keypad works correctly and that it is not damaged.
Use a file to remove burrs from the edges of the guide bar.
Do a check of the connections between the battery and the product. Do a check
of the connection between the battery and the battery charger.
Empty and clean the oil tank.
Blow through the product and battery cooling slots gently with compressed air.
Maintenance and checks of the safety
devices on the product
To do a check of the front hand guard
Regularly do a check of the front hand guard and the
inertia brake release.
1. Make sure that the front hand guard is not damaged
and that there are no defects, such as cracks. (Fig.
94)
2. Make sure that the front hand guard moves freely
and that it is attached safely to the product. (Fig. 95)
3. Put the product, with the motor off, on a stump or
other stable surface.
4. Hold the rear handle and let go of the front handle.
Let the product fall against the stump. (Fig. 96)
5. Make sure that the chain brake engages as the
guide bar hits the stump.
To do a check of the brake trigger
1. Put the product on stable ground and start it. See
Introduction on page 25 .
WARNING:
chain does not touch the ground or other
objects.
2. Wrap your fingers and thumbs around the handles
and hold the product tight. (Fig. 37)
3. Apply full power and tilt your left wrist against the
front hand guard to engage the chain brake. The
saw chain must stop immediately. (Fig. 97)
WARNING:
handle!
1259 - 003 - 14.09.2020
Make sure that the saw
Do not let go of the front
To do a check of the power trigger lockout
1. Make sure that the power trigger and power trigger
lockout move freely and that the return spring works
correctly. (Fig. 98)
2. Press down the power trigger lockout and make sure
that it goes back to its initial position when you
release it. (Fig. 99)
3. Make sure that the power trigger is locked at the idle
position when the power trigger lockout is released.
(Fig. 100)
4. Start the product and apply full power.
5. Release the power trigger and make sure that the
saw chain stops and stays stationary. If the saw
chain rotates when the power trigger is in the idle
position, turn to your servicing dealer.
To do a check of the chain catcher
1. Make sure that there is no damage on the chain
catcher.
2. Make sure that the chain catcher is stable and
attached to the body of the product. (Fig. 41)
To do a check of the keypad
1. Start the product. See
2. Press the start/stop button again.
3. Make sure that the product stops when you press
and hold the button. The green LED will go off. (Fig.
57)
To do a check of the battery and the
battery compartment
1. Clean the battery and the battery compartment with
a soft brush. (Fig. 101)
Before
Weekly Monthly
use
X
X
X
X
X
X
Operation on page 25
X
X
X
31