Setting The Temperature; Adjusting The Radiation Angle; Turning Off; Overheating Protection - Parkside PKH 3000 B1 Bedienungs- Und Sicherheitshinweise

To turn on the product, turn the heating level
switch clockwise .
[ 4 ]
Position Meaning
0
Product turned off
Fan operation
no heating power
Low heating level
1700 W
High heating level
3000 W
NOTES:
Heating level switch
Control light on .
[ 2 ]
Heating level switch
Control light off .
2 ] [
˜ Setting the temperature
To regulate the temperature at high or low
heating level, turn the temperature control
clockwise until it stops .
As soon as the desired temperature has been
reached, turn the temperature control
counter-clockwise until you hear a clicking
sound .
NOTE: The integrated thermostat
automatically turns the heating function on and
off to keep the temperature at a constant level .
Position Meaning
lowest temperature range
low to medium temperature
range
medium to high temperature
range
highest temperature range
14 GB
set to , or
4 ] [
set to 0:
4 ] [
3 ] [
3 ] [
˜ Adjusting the radiation angle
Changing the radiation angle of the air
outlet : Use the knurled screw
[ 5 ]
housing to the desired angle .
NOTE: Do not touch the product with wet
hands or if the product's housing is hot .
˜ Turning off
NOTE: If you have used the product at high
or low heating power, let the product run in fan
mode for about 30 seconds . This will prevent
heat build-up in the housing .
Set the temperature control
:
heating level switch
Disconnect the power plug
outlet .
˜ Overheating protection
The product is equipped with overheating
protection . If the product overheats, the
heating element will turn off automatically .
However, the fan continues to run so that rapid
cooling is achieved . The product will turn on
again automatically once it has cooled down
properly .
m WARNING! There is usually a reason for
overheating! It can indicate a fire hazard!
Check whether the product is giving off
sufficient heat:
Is the product covered or is it too close to a
–
wall or other obstruction?
Is the grid blocked in the front or at the
–
back?
Is the fan blocked?
–
Rectify the problem if possible, or contact the
service hotline (see the section "Service") .
to turn the
[ 6 ]
to and the
[ 3 ]
to 0 .
4 ] [
from the socket-
7 ] [