Initial Start-Up; Operation; Switching On And Off; Controlling The Air Volume And Temperature - Parkside PHLGD 2000 A1 Originalbetriebsanleitung

GB MT

Initial start-up

When used for the first time, some smoke
may escape. The smoke is caused by bind-
ers which are removed from the insulating
film of the heater by the heat during first
use. To ensure that the smoke escapes
quickly, the device should be placed on
the stand area. Be sure to ventilate the
working environment during first use.
If the smoke/odour is too strong, move the
initial start-up to outside!

Operation

Switching ON and OFF

The device has a step switch (5) which
turns the device on and off. The step
switch (5) can also be used to pre-set the
temperature.
Position "0": the device is switched off
Position "I": the device is switched on, the
temperature is 50 degrees
Position "II": the device is switched on, the
temperature can be adjusted to between
50 and 650 degrees via the control panel
(4).
To switch off, turn the s tep switch (5) to
position "0".
Controlling the air volume
and temperature
The air volume and temperature can be
controlled via the control panel (4). The
selected setting is shown in the LCD dis-
play (3).
38
Temperature setting
To control the temperature, the step
switch (5) must be at position "II". The left
and right buttons on the control panel (4,
see next figure also) can be used to set
the temperature at 10 degree intervals.
Increase temperature.
Reduce temperature.
LCD display
- displays the selected temperature
- displays the current temperature
LCD lights up red =
LCD lights up green =
The device has a memory function. The
LCD display shows the last set tempera-
ture and saves it.
Setting the air volume
The air volume can be adjusted to bet-
ween 250 and 500 l per minute. This is
possible from both position "I" and positi-
on "II" of the step switch (5).
Increase air volume.
Reduce air volume.
pre-heating phase
Pre-
set t emperature
reached