Operation; Before Use; Setting Up (As Hot Air Blower); Turn Handle - Parkside PLHLG 2000 A1 Originalbetriebsanleitung

CAUTION!
RISK OF BURNS!
Do not touch the hot nozzle .
►
Wear protective gloves!
■
Wear safety goggles .
■
Always disconnect the mains plug
■
from the socket during breaks in
work, before carrying out any work
on the appliance (e .g . changing the
attachment nozzle) and when not
in use .
Keep the nozzle at a distance from
■
the workpiece or the area being
processed . A build-up of hot air can
result in damage to the appliance .
The appliance must always be kept
■
clean, dry and free from oil or
grease .
Never use the appliance for pur-
■
poses other than the ones for which
it was designed .
PLHLG 2000 A1

Operation

Before use

Select temperature setting:
Use the temperature switch
three temperature settings depending on the
application .
Heating level 1: 100°C
Heating level 2: 350°C
Heating level 3: 650°C

Setting up (as hot air blower)

♦ Plug the mains plug
(230 V alternating current) .
Switching the appliance on:
♦ Turn on the appliance by moving the ON/OFF
switch into the "I" position .
The appliance reaches its full operating
temperature after approx . 1 minute .
Switching the appliance off:
♦ Switch the appliance off by moving the ON/
OFF switch into the "O" position .
♦ After use, always place the appliance on its
stand on a flat, fireproof surface until the
hot parts of the appliance have cooled down .
♦ Pull the mains plug
socket .

Turn handle

The appliance has two handle positions (see fig . A) .
Position 1 is suitable for destroying of weeds and
igniting barbecue charcoal .
Position 2 is suitable for use as a hot air gun .
To change the handle positions, proceed as
follows:
♦ Press the locking knob
to the desired position .
♦ Make sure that the locking knob
relocked .
to choose between
into a suitable socket
from the mains power
and rotate the handle
has
GB │ IE │ 15 ■