Operation; Preparing The Device For Use; Changing The Nozzle; Further Examples Of Uses In The House, Car And Garden - Parkside PHLG 2000 B1 Bedienungs- Und Sicherheitshinweise

using the device, always pull the mains plug
out of the mains socket.
D o not direct the device at the same spot for
too long a period.
M aintain a distance between the jet outlet
nozzle and the workpiece or the surface being
heated. An air blockage could lead to over-
heating of the appliance.
P ay heed to the direct working area and also
to its surroundings. The heat produced could
reach to inflammable articles located out of the
visible area.
A lways keep the device clean, dry and free
of oil or grease.
N ever use the device for a purpose for which it
was not intended.

Operation

Q

Preparing the device for use

Q
CAUTION! When using the device, never
allow the ventilation slots to be covered.
CAUTION! DANGER OF BURNS! Do not
touch the hot nozzle.
Switching on the device:
P ress the ON / OFF switch
or "II".
Switching off the device:
P ress the ON / OFF switch
Adjusting the air quantity and temperature:
You can use the temperature and air quantity control
to set two different blower levels. It is therefore
2
possible to select the appropriate quantity of air and
temperature in accordance with the intended use:
Setting I 300 l / min
Setting II 500 l / min
Use as free-standing unit / during
cooling (see Fig. D):
A lways set the device down upright on
a level surface, this will allow
General safety advice for electrical power tools / Operation
into setting "I"
2
into setting "0".
2
350 °C
550 °C
· you to have both hands free
· the device to cool

Changing the nozzle

Q
Too much heat causes paints
and plastics to ignite.
CAUTION! Do not inhale the resulting vapours.
Protector nozzle
4
and varnish (see Ill. B):
P lace the protector nozzle
outlet tube .
3
T he spatula shape of the nozzle ensures the air
is properly directed. Use a separate spatula for
removing paint or varnish.
Flat nozzle – for detaching glues,
5
softening paint (see Ill. C):
P lace the flat nozzle
D o not apply heat for too long a period, as
burnt paint becomes much more difficult to
remove. Many glues can be softened by warm-
ing. Glued connections can then be detached
and excess glue removed.
Reducing nozzle
6
P lace the reducer nozzle
outlet tube .
3
U se the reducing nozzle
sleeves and film.
Further examples of uses in
Q
the house, car and garden
Defrosting water pipes:
Notice! It must not be used for thawing PVC pipes.
Notice! It is often very difficult to tell the difference
between gas pipes and water pipes. If in doubt, ask
a competent person.
Notice! Copper pipes are joined using tin solder
and must not be heated above 200 °C.
– for removing paint
on the
4
on the outlet tube
5
– for welding plastic:
on the
6
for heat-shrinkable
6
GB
.
3
33