Troubleshooting; Error Correction - Parkside POFA 12 A2 Originalbetriebsanleitung

Troubleshooting

In the event of an accident or malfunction, remove the battery from the device
immediately! Failure to comply may result in injuries from cuts.
Problem
Appliance does not
start
Engine is slower
and stops
The milling is not
straight
The milled work-
piece has burn
marks
The fringes of the
milled part tear off,
there are grooves
and uneven parts
in the milling
Dust is not being
sucked off
Possible cause
Battery (1) discharged
Battery (1) not in
On/off switch (18) is broken
Motor faulty
Device is overloaded through
workpiece
Parallel stop (22) not
inserted
Unsuitable or blunt cutter
Cutting depth is set too large
Cutter is worn out and dull
Cutter blades are damaged
Vacuum is not switched on
Suction hose or suction adapt-
er (21) is clogged

Error correction

Recharge battery (1)
(Observe the separate operating
instructions for the rechargeable
battery and charger)
Insert battery (1)
(Observe the separate operating
instructions for the rechargeable
battery and charger)
Repair by Customer Care
Reduce the pressure
Increase rotation speed
Workpiece unsuitable
Mounting the parallel stop.
Adjust cutting depth
Use the step stop to mill in multi-
ple steps
Change the cutter
Change the cutter
Turn on vacuum before milling
Remove clogging
GB IE
37