Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting; Error Correction - Parkside POF 1200 C2 Originalbetriebsanleitung

Vorschau ausblenden Andere Handbücher für POF 1200 C2:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1

Troubleshooting

Problem
Appliance does not
start
Engine is slower
and stops
The milling is not
straight
The milled work-
piece has burn
marks
The fringes of the
milled part tear off,
there are grooves
and uneven parts
in the milling
Dust is not being
sucked off
Possible cause
No mains voltage
Main circuit breaker is tripped
On/off switch (
Motor faulty
Device is overloaded through
workpiece
The guide bars (
parallel stop (
24) are not
mounted firmly.
Rotation speed too low
Unsuitable or blunt cutter
Cutting depth is set too large
Cutter is worn out and dull
Cutter blades are damaged
Vacuum is not switched on
Suction hose or suction adapt-
er (
20) is clogged

Error correction

Check the socket, power cable,
line, power plug, repairs to be
carried out by qualified electri-
cian if necessary, check main
circuit breaker.
6) is broken
Repair by Customer Care
Reduce the pressure
Increase rotation speed
Workpiece unsuitable
29) of the
If necessary, retighten the screws
of the guide bars.
Increase rotation speed
Change the cutter
Use the step stop to mill in multi-
ple steps
Change the cutter
Change the cutter
Turn on vacuum before milling
Remove clogging
GB
IE
35

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis