Functional Description; Technical Data - Parkside POFA 12 A2 Originalbetriebsanleitung

6-part cutter set:
24 Profile cutter (Ø 25 mm, R 4 mm)
25 Rounding cutter
(Ø 22 mm, R 6.3 mm)
26 V-notch cutter (Ø 12.7 mm,
27 Notch cutter (Ø 12 mm)
28 Notch cutter (Ø 6 mm)
29 Fillet cutter (Ø 22 mm, R 6.3 mm)

Functional description

The battery-powered router cutter is a
power tool equipped with a rotating cut-
ting tool (milling cutter) and a baseplate.
Stepless cutting depth adjustment and dust
suction enable comfortable working.
Refer to the following descriptions for a
functional description of the controls.

Technical data

Cordless Router ......................POFA 12 A2
Motor voltage U
max
Idling speed n ......................19500 rpm
0
Milling cutter diameter .......... max. 36 mm
Rotational speed
of cutter n .....................max. 35000 rpm
Tool holder .......................... 6 mm/8 mm
Weight
(incl. rechargeable battery) .approx.1,1 kg
Sound pressure level
(L ) ...................... 66,8 dB(A); K
pA
Sound power level (L
Vibration (a
) ....... 2,031 m/s
h
Noise and vibration values have been
determined according to the standards and
regulations mentioned in the declaration of
conformity.
The specified vibration emission value and
the stated noise emission value have been
measured according to a standardised test
method and can be used to compare one
power tool with another.
)
......................12 V
=3 dB
pA
) 77,8 dB(A); K
=3 dB
WA WA
; K=1.5 m/s
2
The specified vibration emission value and
the stated noise emission value can also
be used for a provisional assessment of the
load.
90°)
Warning:
The vibration emission value whilst
actually using the power tool may
vary from the given values depend-
ing on the type and way in which
the power tool is used as well as
the type of workpiece being pro-
cessed in particular.
Try to keep the exposure to vibra-
tions as low as possible. One
example of a measure to reduce
vibration exposure when using the
tool is limiting the working hours.
All parts of the operating cycle
have to be considered while doing
so (for example, times when the
power tool is switched off and times
when it is switched on but running
without any load).
Attention! An up-to-date list
of battery compatibility can
be found at:
www.lidl.de/akku
This device can only be operated with the
following rechargeable batteries:
PAPK 12 A1, PAPK 12 A2, PAPK 12 A3
PAPK 12 B1, PAPK 12 B2, PAPK 12 B3.
2
This type of battery may only be charged
with the following chargers:
PLGK 12 A1, PLGK 12 A2, PLGK 12 B2.
Charging
time (h.)
PLGK 12 A1
PLGK 12 A2
PLGK 12 B2
GB
PAPK 12 A1 PAPK 12 B1
PAPK 12 A2 PAPK 12 B2
PAPK 12 A3 PAPK 12 B3
1
1
0,5
IE
2
2
1
25