Safety Socket Connection With Led Brake Lights - Truma Mover SE R Gebrauchsanweisung

Screw socket housing (i) to socket holder (g) using 3 sheet
metal screws (j). (Several alternative positions are available by
using the mounting holes in the socket holder and rotating the
rubber seal.)
Loosely route cable through strain relief (k) and secure with
2 sheet metal screws. Depending on the installation situation,
the cable can be led out of the socket holder through one of
the three recesses.
Pin 6
g
Pin 3
PT 4 x 10
Secure safety socket to the (plastic) shaft cover of the caravan
with 4 bolts, nuts and washers.
M4 x 16
(4 x)
Washer 4,3
(4 x)
No holes must be drilled in the chassis.
Alternatively, the safety socket can be secured using the two
worm drive hose clamps.
Route wire connected to pin 6 (with red stripe) to control unit
(shorten if necessary), crimp on a flat plug and connect as
shown in the connecting diagram.
Route wire connected to pin 3 (black) to control unit (shorten
if necessary), crimp on a ring and screw to negative battery
terminal as shown in connecting diagram.
The connection to the control unit must be made in the
order – nut, battery negative terminal ring, nut, cable
pin 3 ring, nut.
Re-check whether all cables are correctly connected, attached
using the provided clips and cannot chafe.
24
i
B 3.9 x 33
(3 x)
h
j
Nut M4 (4 x)

Safety socket connection with LED brake lights

This connection must always be used if all brake lights
are of the LED variety! With two conventional brake
lights and a third brake light with LED technology, the connec-
tion is made as described in "Safety socket connection with
conventional brake lights".
7-pin safety socket
Connect pin 3 of the caravan plug to the negative battery
terminal.
Connect pin 3 of the safety socket to the controller (with one
wire of the 2-wire cable).
13-pin safety socket
Connect pin 11 of the caravan plug to the negative battery
terminal.
Connect pin 11 of the safety socket to the controller (with one
wire of the 2-wire cable).
k
If it is not possible to make a connection using pin 11 (pin
missing, for example), use pin 3 as an alternative.
It must be ensured that ground connections pin 11
and pin 3 are not interconnected in an electrically
conductive manner at the trailer side!
Connecting diagram with LED brake lights
Fuse
Engagement Safety
motors contact
– + – +
1
6
Safety
7
socket
5
4
7-pin
1
Caravan 6
7
plug
5
4
Drive
motor
Battery
– +
4 3
8
7 9
2
1
6 10
4 2
3
11
5 3
13 12
13-pin
8
7 9
2
1
6
10
4 2
3
3 11
5
13 12
Drive-
motor
2 1 1
-
+