Installation Of Motor Cables And Control Unit - Truma Mover Se R Gebrauchsanweisung

Place the drive units with the crossbar and attachment set (b)
onto the vehicle frame and screw tight with the two screws (c)
so that it is just possible to slide along the frame.
b
b
Position the drive rollers so that they are approximately at the
height of the wheel hub / centre.
Driving direction
If there is a height difference, Truma has 30 mm and 60 mm
spacer sets in its accessory program to compensate the
height difference.
Spacer set 30 mm, part no. 60030-95000,
Spacer set 60 mm, part no. 60030-95100.
Ensure there is enough clearance to the ground
(min. 110 mm).
The correct distance can be set between the tyre and the roller
(20 mm) with the provided spacer by sliding the (disengaged)
drive units in the longitudinal direction. The movable middle
tube makes it possible to adapt to the width of the frame.
Driving direction
Slide drive units in lateral direction so that the maximum
amount of tyre tread is covered.
22
c
min. 110 mm
20 mm
min. 110 mm
Ensure that there is adequate
clearance between the gearbox
and the tyre / shock absorber so
that they do not touch.
The minimum clearance
with the drive units
engaged in is 10 mm.
After positioning correctly, slightly tighten the screws (c) of
the attachment set and then check the defined distances
again. During this, the weight of the caravan must be on the
tyres.
Move sliding middle tube to a central position (e.g. measure
at open side of middle tube with a pocket rule), tighten the
4 bolts (20 Nm) and secure the locknuts.
Recheck that the distance to the tyres
is 20 mm (when the wheels are under
load). Then tighten the 2 screws of
the attachment set (M10) alternately
with a torque of 25 Nm.
The screws are coated with a sealant and may therefore
only be screwed in once.
Fit covering plates
Place covering plate onto housing and fix in position with
3 guide pins in each case (knock in with a hammer or screw-
driver handle).
Installing the position indicator
Push the position indicator into the two holes in the gearbox.

Installation of motor cables and control unit

The Mover® is only suitable for connection to 12 V batteries
(DC voltage).
Remove battery cable terminals and disconnect any
external electrical power before starting work. If you are
unsure about the electrical installation, have it checked out by
a qualified Auto Electrician.
The electrical installation must comply with the technical and
administrative provisions of the respective country in which it
is used (e.g. EN 1648-1). National regulations and guidelines
must be observed.
Two high-power cables for the drive motor and a two-wire
cable for the engagement motor are pre-attached to each mo-
tor. Mark the respective motor connecting cables (motor A
or B – see also wiring diagram) and temporarily route to the
intended control unit installation position on the underbody of
the caravan. An example of a suitable location for the control
unit is in a bed stowage box in close proximity to the manoeu-
vring system, at least 40 cm away from the battery.
25 Nm