Symbols Used; Safety Instructions; General Instructions; Operating Instructions - Truma Mover SE R Gebrauchsanweisung

Mover® SE R / TE R
Table of contents

Symbols used ...................................................................... 15

Safety instructions .......................................................... 15

General instructions ........................................................ 15

Operating instructions
Remote handset .................................................................. 16
Batteries ............................................................................ 16
Function description ........................................................ 16
Remote hand set LED flash codes and acoustic signal ...... 17
Changing the batteries in the remote handset ................... 17
Manoeuvring the caravan ............................................... 17
Hitching to a tow car ....................................................... 17
Maintenance ..................................................................... 17
Checks ................................................................................. 18
Emergency disengaging function ....................................... 18
Trouble-shooting .............................................................. 18
Synchronising the electronic control unit with the radio
remote hand set .................................................................. 18
Technical data ................................................................... 18
Conformity Declaration ................................................... 19
Manufacturer's terms of warranty ................................ 19
Installation instructions
Intended use ........................................................................ 20
Approval .............................................................................. 20
Tools and facilities required ................................................. 20
Minimum installation dimensions ....................................... 20
Measuring the chassis height ............................................. 20
Determining the installation type ........................................ 20
Special accessory installation ............................................. 21
Choice of location ............................................................... 21
Installation of the drive units ......................................... 21
Installation of motor cables and control unit .............. 22
Connecting diagram ........................................................... 23
Connecting the drive motors .............................................. 23
Connecting the engagement motors .................................. 23
Connecting the battery ....................................................... 23
Safety socket connection with conventional brake lights .. 23
Safety socket connection with LED brake lights ................ 24
Commissioning the Mover® ............................................ 25
Warning information ........................................................... 25
Symbols used
Symbol indicates a possible hazard.
Comment including information and tips.
Safety instructions
- The SE R / TE R control systems may only be used for the
Mover® SE R / TE R.
- Practice operating the Mover® in an open area before using
for the first time. This to fully familiarise yourself with
the handset / Mover® operation.
- Always check tyres and drive rollers before using the equip-
ment; remove sharp-edged stones and the like if necessary.
- No person must be present in the caravan during operation.
- All persons (particularly children) must remain outside
the Mover® operating area.
- When operating the mover, ensure that no hairs, fingers or
other body parts, clothing or any other objects carried on
the body can become trapped by moving or rotating parts
(e.g. drive rollers).
- The distance between the radio remote hand set and the
centre of the caravan when manoeuvring must not
exceed 10 m!
- In the event of malfunctions pull on the handbrake.
- To prevent the caravan from tipping, direct the tow hitch
downhill when manoeuvering down a slope.
- After manoeuvring, always apply the handbrake first, dis-
engage the drive rollers from the tyres and block the
wheels (particularly on downwards-sloping surfaces). The
Mover® is not suitable for use as a parking brake for a
parked caravan.
- Ensure that remote radio control is protected from unau-
thorised access (particularly by children!).
- Never tow the caravan with the drive rollers applied. This
can cause damage to the tyres, the towing vehicle and the
drive units.
- All wheels and tyres on the caravan must be of the same
size and design.
- In order to ensure that the Mover® operates correctly, the
distance between the tyres and the disengaged drive rollers
must be 20 mm. All tyres must have the same inflation pres-
sure as per the manufacturer's instructions (check at regu-
lar intervals!). If tyres are worn or new tyres are fitted, the
distance between the drive rollers and the tyres may need
readjusting (see "Installation of the drive units").
- Do not use the Mover® as a support when jacking up the
caravan, since this can damage the drive unit.
- Sensitive objects such as cameras, DVD-Players etc. must
not be kept in the stowage box near the control unit or the
motor cable. They can be damaged by the electromagnetic
fields.
- The empty weight of the vehicle increases by the weight of
the Mover®, which reduces the payload of the vehicle.
- Remove plug from safety socket after manoeuvring,
otherwise the battery will be discharged.
Standby current with plug inserted approx. 200 mA.
Standby current with plug removed < 1 mA.
General instructions
The Mover® SE R was developed for overcoming inclines of
up to approx. 25 % with a gross weight of 1200 kg and 15 %
with a gross weight of 2000 kg,
and the Mover® TE R for overcoming inclines of up to approx.
25 % with a gross weight of 1200 kg and 10 % with a gross
weight of 2250 kg on a suitable surface.
Depending on the weight of the caravan, the Mover® can-
not overcome obstructions that are more than about 3 cm in
height without assistance (please use wedges as a ramp).
Due to the nature of a radio signal, it can get corrupted by ex-
ternal terrain or objects. So there may be small areas around
the caravan where the quality of reception reduces, hence the
Mover® may stop momentarily.
When the Mover® is switched off using the remote
control the control unit remains in standby. In order to
switch off completely the battery must be disconnected or an
isolating switch installed.
15