AEG ITE42600KB Benutzerinformation Seite 71

Problem
An acoustic signal sounds and the
appliance deactivates. An acoustic
signal sounds when the appliance is
deactivated.
The appliance deactivates.
Residual heat indicator does not
come on.
The sensor fields become hot.
There is no sound when you touch
the panel sensor fields.
comes on.
The control bar blinks.
and a number come on.
You can hear a constant beep
noise.
8.2 If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre. Give the data
from the rating plate. Make sure, you
operated the hob correctly. If not the
Possible cause
You touched 2 or more sensor fields
at the same time.
There is water or fat stains on the
control panel.
You put something on one or more
sensor fields.
You put something on the sensor
field .
A zone is not hot because it operat‐
ed only for a short time
The cookware is too large or you put
it too near to the controls.
The sounds are deactivated.
Child Safety Device or Lock oper‐
ate.
There is no cookware on the zone
or the zone is not fully covered.
The cookware is unsuitable.
The diameter of the bottom of the
cookware is too small for the zone.
There is an error in the appliance.
The electrical connection is incor‐
rect.
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The information about
guarantee period and Authorised Service
Centres are in the guarantee booklet.
Remedy
Touch only one sensor field.
Clean the control panel.
Remove the object from the sensor
fields.
Remove the object from the sensor
field.
If the zone operated sufficiently long
to be hot, speak to an Authorised
Service Centre.
Put large cookware on the rear
zones, if possible.
Activate the sounds.
Refer to "Daily use".
Refer to "Daily use".
Put cookware on the zone so that it
fully covers the roasting zone.
Use suitable cookware. Refer to
"Hints and tips".
Use cookware with correct dimen‐
sions. Refer to "Technical data".
Deactivate the appliance and acti‐
vate it again after 30 seconds. If
comes on again, disconnect the ap‐
pliance from the electrical supply.
After 30 seconds, connect the appli‐
ance again. If the problem contin‐
ues, speak to an Authorised Service
Centre.
Disconnect the appliance from the
electrical supply. Ask a qualified
electrician to check the installation.
ENGLISH 71