Control Of The Under-Bed Lighting; Controlling Safesense Under-Bed Lighting Via The Go Button - wissner-bosserhoff SafeLift Gebrauchsanweisung

5.4 Control of the under-bed lighting

2
1
3
3
1
2
If the motor already has a underbed light, it is recommended to disconnect it
from the motor during the permanent use of SafeLift or SafeSense
5.5 Controlling SafeSense
2
1
3
3
1
2
- The under-bed lighting is automatically activated
each time the GO button is pressed
2
- to switch off this function, first press the LC key on
the box and then the key combination as shown
3
in the figure.
- to switch this function on again, press the keys as
3 shown in the illustration in reverse order
2
under-bed lighting via the GO button
®
- Switch off control of the under-bed lighting using
the GO-button according to section 6.4
4
- Perform key combination according to illustration
3
- Use the keys in reverse order to reset this func-
tion.
3
4
.
®
43