Operating Plan - wissner-bosserhoff SafeLift Gebrauchsanweisung

3.3 Operating plan

Height adjustment
up
down
By pressing a button on the controller, signals are transmitted to the box by radio, which allows
the corresponding adjustments/actions to be carried out.
In addition to the adjustment functions for the backrest and the height adjustment, further
functions can be carried out via the SafeLift Controller using key combinations. These are
explained in detail in Chapter 5 "Functions".
To activate the controller, the GO button must be pressed before each action. The
controller is thus enabled for 20 seconds for adjustment functions (backrest and
height adjustment) and 2 seconds for all additional functions. Once the period
has expired, the GO button must be pressed again.
Handset and SafeLift Controller
The handset has a priority function over the SafeLift controller. If the handset is operated
during an adjustment process with the SafeLift Controller, the function controlled by the
controller stops and the command from the handset is executed. In this case, the LED on
the SafeLift Box lights up in red.
Status of the LED
Color of the status LED
red
Flashing (red/green)
red for 5 sec., then green
green
red
red
34
GO-Button
Backrest
up
down
LC-button
Status
No transmitter programmed
Programming process active
All memory locations occupied
Ready for operation
Lock
Handset has been operated
Status-LED