Fuse Replacement; Cleaning - Renkforce BT-RSD1802K Bedienungsanleitung

Maintenance
Before cleaning the SD tuner or performing maintenance, the following safety information must be observed:
Live components may be exposed if covers are opened or components are removed.
The device must be disconnected from all power sources before any servicing or repair work
is carried out.
Capacitors inside the device may still carry voltage even though they have been disconnected
from all power sources.
Only qualified experts familiar with the hazards involved and the relevant regulations must
perform repairs.

Fuse Replacement

If it becomes necessary to replace a fuse, make sure that only fuses of the prescribed type and nominal current are
used (see "Technical Data").
Never repair fuses or bridge the fuse holder.
• When the power supply has been disconnected (disconnect ISO plug!) carefully remove the fuse from the fuse
holder next to the ISO plug.
• Replace it with a fuse of the same type.
• Only then can you reconnect the SD tuner to the electric on-board system and turn it on.
• Should the fuse trigger again, have the SD tuner repaired in a specialised workshop.

Cleaning

Clean the exterior of the device with a soft, dry cloth or brush only.
Never use any aggressive cleaning agents or chemical solutions that may damage the surface of the casing.
77