Remote Control - Renkforce BT-RSD1802K Bedienungsanleitung

Mechanical Installation

Remote Control

The remote control can be attached right to the steering wheel rim with the included steering wheel holder. The IR
reception eye is located in the front cover of the SD tuner.
Steering wheel assembly:
• Align the steering wheel straight.
• Open the two screws (E) of the steering wheel holder.
• Place the inner part (A) of the steering wheel holder on the inside of the steering wheel (C).
• Pull the rubber band (B) around the steering wheel rim and hook it into the latching tabs under tension (figure 1).
• Cut off any excess rubber band (figure 2).
• Attach the outer part (D) of the steering wheel holder again with the two screws (E) (figure 3).
• Push the remote control onto the steering wheel holder (figures 4 and 5).
• To remove the remote control, operate the safety lever (F) and pull the remote control from the holder (figure 6).
52

Operating Instructions
English