1. Strip 10 mm of insulation from the DC conductor (
2
) using a suitable tool.
6 mm
Make sure that no individual strands are cut off.
2. Insert stripped conductors into the corresponding
crimp contact sleeve up to the stop. The conductor
ends must be visible in the crimp contact sleeve.
3. Crimp conductor and crimp contact sleeve with
crimping pliers.
4. Check that the ladder is firmly seated.
REFUsol 50K-3T
982081 | 03 | 2021-03
4 –
Fig. 37: DC cable assembly with MC4 connector
Assembling and Connecting DC Cables
+
[kl k]
Installation
37