Packing The Glider - Nova XENON Bedienungsanleitung

_64

Packing the glider

The following shows the recommended packing method which best
protects the equipment. Of course, depending on preference and situ-
ation, other packing methods can also be used.
1. Gather the glider in the shape of a rosette and place it next to the
Concertina Bag Light
2. Pull the wing tip of the opposite side once over the entire rosette
and place in the middle of the Concertina Bag next to it
3. Lay the top surface rods profile rib by profile rib on top of each other
– fold the whole canopy until the other wing tip is on top
4. Then lay the lines lengthwise with a few turns next to/on the wing
5. Use the net to fix the wing at the top of the nose and the buckle to
fix the middle section of the glider
6. Place the risers in the riser bag
7. Fully close the zip
8. Pull the top and bottom straps to close
9. Fold the Concertina Bag into thirds and place the inflated Pack Roll
across, between the first and second thirds of the Concertina Bag
(this refers to the third between the nose and the middle of the wing)
to protect the rods from bending too much
10. Close at the end with compression system
1
3 3
5 6
8 9
_65 _EN
2
4
7
10