Pullup & Dip FREESIXD Benutzerhandbuch Seite 57

7.3| mounting outdoor
mounting steps
Step 1:
Material required:
2 Outdoor Adapters
䕲
2 tension straps
䕲
Step 2:
Thread the tensioning strap into Outdoor Adapter: from the outside to the inside and again
from the inside to the outside. Note that the tensioning strap must be threaded in such a
way that the open ratchet with the flat actuator points downwards (see illustration).
Step 3:
Place the strap around the tree/pole and insert it into the open ratchet at the desired
height at the top and tighten (use of the ratchet, please see on the next page).
Step 4:
Carry out the same procedure for the lower attachment point. Make sure that both
adapters are placed in line vertically.
57