Continuous Measurement Mode - Parkside PLEM 50 C2 Bedienungs- Und Sicherheitshinweise

Note:
- Repeat the step 1 to 4 if needed to measure another distance.
- Distance Measurement mode icon
under single measurement mode.
- Maximum up to 4 measured values can be shown on the
display at a same time.
- If no button is pressed for 30 seconds, the laser and display
back-light will turn off. If no button is pressed for 3 minutes,
the product will power off itself.

Continuous Measurement mode

Continuous measurement involves taking series of measurements
from which the maximum (MAX) and minimum (MIN) values are
displayed. To do this, move the product along a base surface or an
edge from which you wish to the measure a distances. You can, for
example, measure how parallel two opposite walls are or measure
the maximum values while using a function.
1. Start the continuous measurement by briefly pressing the con-
tinuous measurement button
be observed to get first measured value on the display. This is
common. Now, each measured value will be shown on the
display.
2. Stop the measurement by pressing the continuous measurement
button
. The display now shows the maximum (MAX) and minimum
8
(MIN) values
last measured value.
48 GB/IE
or MEAS button
14
of that particular measurement series and the
21
will stay on (not flashing)
26
. A very short delay could
14
or return / Clear button
16