Measuring Lengths; Single Measurement Mode - Parkside PLEM 50 C2 Bedienungs- Und Sicherheitshinweise

point is at the back of the product. The end piece at the reference
33
point can be unfolded as shown in the fig D using a sharp tool
33
(example: flat screwdriver) or finger nail. Once finished using, the end
piece at the reference point

Measuring lengths

Single Measurement mode

1. Place or hold the reference plane of the product on or against
the desired base surface from which you want to determine a
distance.
2. Check the flatness of the product by use of both the spirit levels
. One of the bubble level is for checking horizontal flatness
6
and the other air bubble is for checking vertical flatness. To,
check the flatness of certain angle, make sure that bubble is
positioned at the middle of respective angle bubble level.
3. Briefly press the MEAS button
the laser is switched on, it is indicated by the laser on icon
on the display.
Note: Step 3 can be skipped if the laser beam is already
activated.
4. Now aim the laser at the target point and press the MEAS
button
16
measurement is successful, the measured result will be shown
on the bottom row
are pushed upwards.
has to be folded-back for future use.
33
briefly again to take a measurement. If the
of the display. The previous readings
23
to activate the laser. Once
16
31
GB/IE 47