Start-Up; Power On / Off; Acoustic Signal - Parkside PLEM 50 C2 Bedienungs- Und Sicherheitshinweise

however, you must replace the batteries. Measurements are no
longer possible.
Open the battery compartment cover
down the battery compartment cover latch
Remove the used batteries from the battery compartment
if necessary.
Insert the (new) batteries. Ensure the correct polarity as shown
on the diagram inside the battery compartment
Replace the battery compartment cover

Start-up



Power ON / OFF

Press power button
beam will be activated from the laser beam output opening
Laser on icon
Press and hold the power button
off to power off the product. The laser beam flashes again shortly
before it is finally switched off.
Note: If no button is pressed for 30 seconds, laser beam will be
turned off automatically. If no button is pressed for 3 minutes, the
product will automatically power off itself.

Acoustic signal:

- Each press of a button and every error-free function that is carried
out is confirmed by a short beep.
- A double beep will be heard in the event of any fault.
44 GB/IE
to power on the product. The laser
11
will also be shown on the display
31
by gently pushing
5b
.
32
.
5a
as shown (fig. A).
5b
until the LC display turns
11
,
5a
.
4
.
2