Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

2.2 - WALL MOUNT INSTALLATION

Wall mount installation is common for all charging station models.
1-
Open the product front cover following the instructions for cover opening under section 5.2.
2-
Center the charging station using the alignment template, and mark the drill bit holes with a
pencil.
3-
Drill the wall on the marked points using the impact drill (8mm drill bit).
4-
Place the dowels into the holes.
5-
Tighten the security scews (M6x75) of the product using Torx T25 Security Screwdriver.
6-
Insert the open lead wires into the charging station through the hole on the lower left. Follow
the AC Mains Connection instructions on the next pages, see section 2.3 or 2.4 depending on the
model of the charger. (Single/Three Phase)
7-
In case you mount the charging station to conductive metal surface, you can make ground
connection via "right-bottom" screw using Earth extension cable as shown in figure-6.
To ensure the grounding, you need to change the grounding cable position from "a" to "b" as shown
in figure-6. Follow the instructions below:
i. Insert the plastic support, which is inside the artwork pack, to the fixing hole (Position "b")
ii. Fix the grounding cable using the M6x30 screw, which is inside the artwork pack and this screw
is also used to assemble to product to the conductive metal surface.
8-
Tighten the cable glands as shown in the figure. Before close the cover of the charging station,
follow instructions in sections 2.6 and 2.7 if any function related to these sections are used.
NOTE : Also check section 3 commissioning.
9-
To close the cover of the charging station, tighten the cover screws that you removed before
with Torx T20 Security L-Wrench or Right Angle Screwdriver Adapter using Torx T20 Security Bit.
10-
Mounting the charging station on wall is now finished.
3
Before next step (7), Please check the instructions for Single Phase or
Three Phase cable connections in sections 2.3 or 2.4.
IG v7.3.0 2021
1
4
Figure-5
© 2021 Vestel - All rights reserved
2
5
6
English - 15

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis