Operation - Cameo F4 FC PO IP65 Bedienungsanleitung

PRESSURE EQUALIZATION ELEMENT
The spotlight features pressure equalization elements to keep as little condensation as possible from forming inside the enclosure.
NOTE: The input and output connectors must be protected against splashing water in accordance with the protection rating IP65 by correct-
ly blanking them with the corresponding IP65 plugs or the rubber blanking caps.

OPERATION

NOTE
• As soon as the spotlight is correctly connected to the power mains, "Welcome to Cameo", the model designation, and then the software
version are displayed in sequence on the display as part of the startup process. Once the process is complete, the spotlight is ready for use
and resumes whichever mode was most recently activated.
• If one of the DMX modes or the Slave mode is active and no control signal is present at the DMX input, then the symbols on the display
will begin to blink.
• If no input is received within approx. 1 minute, then the currently activated operating mode will be shown automatically on the display
(main display).
DISPLAY MAIN DISPLAY DMX OPERATING MODE
The main display in DMX mode shows the currently configured DMX start address, the DMX mode and other information (see illustration).
currently activated mode
DMX start address and DMX mode
Press encoder =
select mode
SETTING THE DMX START ADDRESS (DMX Address)
Starting from the main display, press on the right push button rotary encoder to move to the main menu. Rotate the left encoder (SELECT) to
select the "DMX Address" menu item (as indicated by selector arrow on left) and confirm by pressing the encoder (ENTER). You can now config-
ure the DMX start address as desired by rotating the left encoder (highest value reflects the active DMX operating mode). At the same time, the
following address, i.e. the DMX start address derived from the selected start address plus the channel number for the selected DMX mode, is
also shown. Confirm the entry by pressing on the left encoder (ENTER), which then returns you automatically to the main display and activates
the DMX mode. The menu item for selecting the desired DMX mode is reached directly from the "DMX Address" menu item by pressing on the
middle push button rotary encoder (DMX mode), while the previously configured DMX start address is then saved automatically.
Rotate encoder =
change value
Press encoder =
confirm change to value (enter)
6
= DMX signal present = no DMX signal
 
4CH Direct
Press encoder =
select the DMX mode
Fan mode
Press encoder =
Open main menu
Press encoder =
Open main menu