Factory Calibration - Cameo F4 FC PO IP65 Bedienungsanleitung

Dimmer Curve =
Dimmer Response =
Red Shift =
PWM Frequency =
Color Calibration =
Autolock =
Fan =
Factory Reset =
UC/Loops Reset =
12
Dimmer Curve Linear
Exponential
Logarithmic
S-curve
Dimmer behavior LED
Halogen
No
Imitates color drift by
dimming one of the
Dim To Warm
halogen spotlights. The
dimming of the spotlight
automatically changes
the color temperature
along a rising curve of
warm white and amber
(and vice-versa).
LED PWM frequency 600 Hz / 1200 Hz /
2000 Hz / 4000 Hz /
6000 Hz / 25k Hz
Calibration of the color RAW
User Calibration
(Custom adjustment of
R, G, B, and W by values
ranging from 000 to
255, independent of
mode)

Factory Calibration

Automatically locks the On
control element
Off
Fan settings Auto
Silent
Restores factory Reset Now?
defaults
(but does not reset user
colors or loops)
Resets user colors and Reset User Colors/
loops to factory defaults Loops
The light intensity climbs linearly with the DMX value
The light intensity can be set finely in the
lower DMX value range and roughly in the
upper DMX value range
The light intensity can be set roughly in the
lower DMX value range and finely in the
upper DMX value range
The light intensity can be set finely in the lower and
upper DMX value ranges and roughly in the medium
DMX value range
The spotlight reacts abruptly to changes in the DMX
value.
The spotlight behaves similar to a
halogen spotlight with soft changes in brightness.
Color drift deactivated
Color drift activated
Sets the LED PWM frequency
R, G, B and W with maximum value of 255
Press center encoder = Switch between R+G and
B+W (Color)
Rotate center encoder = Configure value of R or B
Press right encoder = Move up one level in the menu
navigation (ESC)
Rotate right encoder = Configure value of G or W
Press left encoder = Confirm and save settings
Factory preset calibration of R, G, B and W
(independent of mode). Select this setting for correct
depiction of color tones and presets in the stand-alone
modes CCT and Gel, as well as to activate CCT and the
Gel presets via DMX.
Automatically locks the control element after approx.
30 seconds of inactivity. If a subsequent attempt is
made to use controls, display shows: "Locked!"
Unlock method: simultaneous pressing of center and
right encoder for approx. 3 seconds
Deactivates automatic locking of the control element
Automatic fan control
Fan deactivated, brightness reduced
Reset to factory defaults:
confirm with ENTER, abort with ESC
Reset to factory defaults:
confirm with ENTER, abort with ESC