Introduction - Cameo F4 FC PO IP65 Bedienungsanleitung

33. Dust and other debris inside the unit may cause damage. The unit should be regularly serviced or cleaned (no guarantee) depending on
ambient conditions (dust etc., nicotine, fog) by qualified personnel to prevent overheating and malfunction.
34. Please keep a distance of at least 0.5 m to any combustible materials.
35. Only use the power cable provided to connect the device to the power supply.
36. The appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge.
37. Children must be instructed not to play with the device.
38. If the power cord of the device is damaged, do not use the device. The power cord must be replaced by an adequate cable or assembly
from an authorized service center.
The warning triangle with lightning symbol indicates dangerous uninsulated voltage inside the unit, which may cause an
electrical shock.
The warning triangle with exclamation mark indicates important operating and maintenance instructions.
Warning! This symbol indicates a hot surface. Certain parts of the housing can become hot during operation. After use, wait for
a cool-down period of at least 10 minutes before handling or transporting the device.
Warning! This device is designed for use below 2000 metres in altitude.
Warning! This product is not intended for use in tropical climates.
Caution! Intense LED light source! Risk of eye damage. Do not look into the light source.
CAUTION! IMPORTANT INFORMATION ABOUT LIGHTING PRODUCTS!
1. Do not stare, even temporarily, directly into the light beam.
2. Do not look at the beam directly with optical instruments such as magnifiers.
3. Strobe effects may cause epileptic seizures in sensitive people! People with epilepsy should definitely avoid places where
strobe effects are used.

INTRODUCTION

CONTROL FUNCTIONS
1-channel, 2-channel DIM, 2-channel CCT, 3-channel RGB, 4-channel RGBW, 4-channel CCT, 6-channel HSI/CCT, 7-channel RGB/CCT,
8-channel RGBW 16Bit, 10-channel HSI/CCT, 16-channel RGBW/CCT 16Bit
Master / slave mode
Stand-alone functions
PROPERTIES
1x High Power 570 W RGBW LED. 14°–50° beam angle, manual zoom. Zoom, pan and tilt adjustable via control rod. IP65 protection rating.
250 mm Fresnel lens. Configurable PWM frequency (flicker free). DMX-512 control. RDM enabled. Manual control. 4 dimmer curves. 16-bit
dimming. Master/slave mode. Extremely quiet operation thanks to heat pipe cooling and IP65 fan. Operating voltage: 100–240 V AC / 50–60
Hz. Power consumption 350 W. Mounting bracket, filter frame and 8-way barn door included.
The spotlight complies with the RDM standard (Remote Device Management). This device manager allows the user to request the status of
and configure RDM end devices via an RDM-capable controller.
4
CAUTION:
To reduce the risk of electric shock, do not remove cover (or back). There are no user serviceable
parts inside. Maintenance and repairs should be exclusively carried out by qualified service
personnel.