Slave Mode; Dmx Mode - Cameo F4 FC PO IP65 Bedienungsanleitung

SLAVE MODE

Starting from the main display, press on the left push button rotary encoder to move to the mode selection menu. Rotate the left encoder
to select the "Slave" menu item (as indicated by selector arrow on left) and confirm by pressing the encoder (ENTER). Slave mode is now
activated and the main display is automatically shown again. Connect the slave and master unit (same model, same software version) using
a DMX cable, and activate one of the stand-alone modes on the master unit. The slave unit will now follow the master unit.
currently activated mode
Press encoder =
select mode

DMX MODE

Starting from the main display, press on the left push button rotary encoder to move to the mode selection menu. Rotate the left encoder
to select the "DMX" menu item (as indicated by selector arrow on left) and confirm by pressing the encoder (ENTER). DMX mode is now
activated and the main display is automatically shown again. Select one of the ten available DMX modes in the menu item "DMX Mode" in
the main menu (see SET DMX MODE).
DEVICE SETTINGS (Settings)
Starting from the main display, press on the right push button rotary encoder to move to the main menu. Rotate the left encoder (SELECT) to select
"Settings" menu item (as indicated by selector arrow on left) and confirm by pressing the left encoder (ENTER). This will take you to the submenu
for setting the submenu options (see table, select via SELECT, confirm via ENTER, change value or status via SELECT, confirm via ENTER).
Settings (bold = factory setting)
Display Flip = Flips the display
Display Time off = Display backlight
DMX Fail = operating mode if DMX
signal is lost
Standing Position
No rotation of display
Hanging Position Display rotates by 180°
(such as when installed overhead)
Display always on permanently on
Display off after 20s
deactivates after approx. 20 seconds of inactivity
Hold last command is held
Blackout activates Blackout
User Color 8 activates User Color 8
Fan mode
Press encoder =
Open main menu
11