Warranty; Scope Of The Warranty - Atlantic EGEO Betriebs Und Installationsanleitung

Product
presentation
1.

Scope of the Warranty

This warranty does not cover malfunctions due to
Abnormal environmental conditions:
Various damages caused by shocks or falls during handling after leaving the factory.
Installing the appliance in a location subject to freezing or to bad weather (moist, harsh environment or
poorly ventilated).
Using water with hardness criteria as defined in DTU Plumbing 60-1 addenum 4 hot water (DTU
Plomberie 60-1 additif eau chaude - (chlorides, sulphates, calcium, resistivity and TAC (complete
alkametric titration)).
Water with a Th < 15 °f (Total hardness).
Water pressure above 0.5 MPa (5 bar).
Power supply with significant surges (main supply, lightning...).
Damages resulting from problems that could not be detected due to the choice of the installation location
(difficult access) and which could have been avoided by immediate repair of the appliance.
An installation that is not in compliance with regulations, standards and best practices, including:
The safety unit was removed or not functioning (pressure reducing device, check valve or valve, ...,
placed upstream of the safety unit).
No safety unit or incorrect installation of a new safety unit in compliance with the NF EN 1487 standard,
change of its calibration...
No sleeves (cast iron, steel or insulating) on hot water connection pipes which could lead to corrosion.
Faulty electrical connection: not in compliance with NFC 15-100, improper grounding, insufficient cable
length, connection with flexible cables without metal ends, failure to comply with the wiring diagrams as
recommended by the manufacturer.
Turning on the power to the appliance before filling it (dry heating).
Positioning the appliance not in compliance with the instructions in the operating manual.
External corrosion due to poor water tightness of the piping.
Installation of a domestic hot water recirculation system.
Incorrect settings for an installation with clad lining.
Cladding not in compliance with our recommendations.
Improper maintenance:
Abnormal scaling of heating components or safety units.
No maintenance of the safety unit resulting in overpressure.
No cleaning of the evaporator and condensate drainage.
Alteration of the original equipment, without contacting the manufacturer or using spare parts not
referenced by the manufacturer.
An appliance with suspected damages must remain at the location available to the expert, the
owner must inform his insurer.
64
Installation
:
Maintenance,
Settings /
Servicing and
Operation
Troubleshooting

Warranty

Warranty