Settings / Operation; Control Panel; Pictogram Description - Atlantic EGEO Betriebs Und Installationsanleitung

Product
presentation
1.

Control panel

Power strip
Heat pump operation
indicator
Adjusting the set point
temperature
Mode selection dial
Absence mode
2.

Pictogram description

Symbol
Heat Pump
Compressor and fan
Electric booster pump
Installer indicator
Acknowledging malfunction
message button
Eco mode
Absence mode
Adjusting the desired/set
point temperature
Settings /
Installation
Operation

Settings / Operation

Name
This LED indicates that the heat pump is in operation.
This LED indicates that the electric booster pump is in Operation.
This LED indicates the presence of a malfunction (solid) or the
standby mode is on (flashing)
A short press on this button acknowledges the malfunction.
A long push allows you to switch to standby mode.
This is to be done only on the request of the customer service.
This LED indicates that the ECO mode is activated.
Select this mode to reduce the production of hot water to maximize
energy savings (T° = 54° C).
This LED indicates that the ABSENCE mode is activated. Select this
mode for freeze protection (15°C) of the water heater and for an
extended absence.
This LED indicates that the manual set point temperature setting is
activated. Use the dial to set the set point temperature between 50°C
and 62°C.
Maintenance,
Servicing and
Troubleshooting
Acknowledging
Malfunction message
and standby mode
button
Installer indicator
Electric booster pump
operation indicator
ECO mode (set point
temperature at 54°C)
Description
Warranty
EN
53