Error Codes - Atlantic EGEO Betriebs Und Installationsanleitung

Product
presentation
Error code
Err 21 Electrical malfunction
of the air sensor
Err 22 Electrical malfunction
of the steam sensor
Err 305 Inconsistency of the sensors
4.1.2. Problem / solving heat pump malfunction indication

Error codes

Err 25 Compressor power supply
malfunction
Err 28 Defrosting inefficiency
Err 301 No heating of the heat pump
(PAC)
Err 302 Fluid leak
Err 303 Evacuation problem
Err 304 Exiting MAP (Sortie de MAP)
4.2. Error codes
The alarm can be suspended or reset by pressing (short press) the Acknowledgment button (see the "Control panel"
section).
4.2.1. "Tank" error codes
Error codes
Err 03 Malfunction of
Electrical
malfunction
of the water sensor or out of range
The tank has no
Err 07
water or the ACI
ACI malfunction
connection is open
Err 09
Water too hot
Settings /
Installation
Operation
Causes Consequences
Unable to read
the water
the water temperature:
temperature
no heating.
No heating
The water Risk of
temperature activating the mechanical
is too hot safety device: no
(T>80°C) heating.
Maintenance,
Servicing and
Troubleshooting
Indication
The LED will flash 7 times
The LED will flash 9 times
The LED will flash 11 times
Indications
The LED will flash twice
The LED will flash 3 times
The LED will flash 4 times
The LED will flash 5 times
The LED will flash 7 times
The LED will flash 9 times
Troubleshooting
Check the connection (mark A1) of the water
temperature sensor (immersion sleeve).
Check the absence of moisture in the immersion
sleeve where the sensor is located.
If necessary, replace the sensor.
Fill the tank with water.
Check the ACI circuit (connection, wiring and
water conductivity, ...)
Check if the actual water temperature at the
point of use is high (T> 80°C).
Check the connection (mark A1) and the
position of the water temperature sensor
(immersion sleeve).
Check if the electric booster pump is
continuously functioning. Reset the mechanical
safety device if necessary.
Warranty
EN
59