Manual DU
05-08-1999 10:38
RADIO FREQUENCY INTERFERENCE STATEMENT
Each FastTrak66 Ultra ATA/66 RAID card is equipped with an FCC
compliance label and shows an FCC identification number. The full text of
the associated label is:
CAUTION: Changes or modifications to the FastTrak66 not expressly
approved by PROMISE TECHNOLOGY, INC. could void the userÕs
authority to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy, and, if not installed and used in accordance with the instruc-
tion may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult Promise Technology, Inc. or an experienced radio/TV technician for
help.
This device complies with Part 5 of the FCC Rules. Operation is subject to the
following conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
NOTE: Only digital device equipment CERTIFIED CLASS B should
be attached to this equipment and that must have shielded cables.
Pagina 2
2