Bed Production Procedure - Checchi & Magli AL Bedienungs- Und Wartungsanleitung

A
B
UN41-0318LI
6) Insert the pins (C) into the lift arms and fit in the lock
pins (D).
7) Turn the tie-rod (E) to adjust the space between the
tie-rod and the upper coupling (F) on the support
frame.
8) Insert the pin (G) and the lock pin (H).
9) Adjust the tie-rod (E) so that the work vehicle is paral-
lel with the ground.

Bed production procedure

The bed must be made on soil which has been suffi-
ciently crushed and levelled and properly prepared with
a harrow or cultivator.
Do not make the bed on overly wet soil.
To make the bed, proceed as outlined.
1) Lift the work vehicle slightly off the ground.
2) Adjust the forming sides to determine the bed di-
mensions (see "Adjusting the forming sides").
3) Adjust the external conveying shares to ensure the
right amount of soil is conveyed to make the bed (see
"Adjusting external conveying shares").
4) Adjust the internal conveying shares to convey the
right amount of soil towards the centre of the bed
(see "Adjusting internal conveying shares").
English language
INFORMATION FOR USE
E
A
For unhitching, proceed as outlined below ___________
1) Select an area with flat, solid ground to park the work
vehicle - tractor.
2) Using the tractor's controls, lower the work vehicle to
the ground.
3) Switch off the tractor engine and remove the ignition
key from the dashboard.
4) Take out the lock pin (H) and remove the pin (G).
5) Slide out the lock pins (D) and remove the lift arms
(B) from the work vehicle's support frame.
5) Adjust the support wheels to ensure the compact-
ing roller packs the soil as needed (see "Adjusting the
support wheels").
6) Using the tractor's controls, lower the work vehicle to
the ground.
7) Move the work vehicle forwards and check that all
the conditions are right and if not, make the relevant
adjustments.
Information
When making the bed, do not reverse the work vehi-
cle to avoid damaging its mechanical parts.
Before engaging the reverse gear, lift the machine
off the ground.
27
6
E
Use and maintenance