Electrical Connection; Tank Filling; Use Procedure; Information For Use - Checchi & Magli WOLF PRO Bedienungs- Und Wartungsanleitung

- Yellow and blue light flashing at the same time: low
power supply (battery is flat).

Electrical connection

Carry out the operations described.
1) Connect the power supply connec-
tors (B).
2) Connect the connectors (C) to each
planting unit in any order.
3) Turn the key (A) on the main discon-
necting switch to the "OFF" position
to switch off the power supply.

Tank filling

NOTICE
Use clean water without suspended sediments to
avoid compromising the use of the device.
Check that the filter (C) is intact and correctly assem-
bled.
Proceed as outlined below.
1) Turn the key (A) of the main switch to the "OFF" posi-
tion to cut off the power supply.
2) Remove the cover (B).
3) Pour the water or the fertiliser solution into the tank
through the filter (C).
- The liquid level can be seen using level gauge (D).
4) Fit the lid to close the tank.

Use procedure

1) Turn the tap (A) partially or fully to turn on the supply
to the watering system.
2) Turn the key (B) on the main switch to the "ON" po-
sition to close the electrical circuit and activate the
device.
3) Begin planting (see "Instructions for planting") for the
work vehicle on which the device is installed.
- During planting, check that the seedling is sprayed
fully and if it is not, make the necessary corrections
(see "Spray Adjustment" and "Adjusting the flow onto
the seedling").
English language

INFORMATION FOR USE

- Red light on permanently and blue light flashing:
the electric pump has been running at low speed for a
prolonged period and has stopped.
A
B
UN41-0933UA
UN41-0934UA
UN41-0941UA
9
D
A
B
6
C
B
C
A
Use and maintenance