Inserting An Sds Plus Tool; Removing An Sds Plus Tool; Inserting Tools With Hexagonal And Cylindrical Shafts; Removing Tools With Hexagonal And Cylindrical Shafts - Parkside PBHA 12 A1 Originalbetriebsanleitung

GB IE

Inserting an SDS Plus tool

1. Unlock the SDS Plus receptor (1) by
pulling the locking sleeve (3) back-
wards.
2. Rotate the tool into the tool holder.
3. Release the locking sleeve (3)
4. Check that the tool is secure by pulling
on it. The tool exhibits some radial
play for technical reasons.

Removing an SDS Plus tool

1 Pull the locking sleeve (3) backwards
and remove the attachment tool.
Inserting tools with hexagonal
and cylindrical shafts
1. Unlock the SDS Plus receptor (1)
by pulling the locking sleeve (3)
backwards.
2. Rotate the keyless chuck with SDS
Plus adapter (17) into the tool hol-
der (1).
3. Check that the keyless chuck (17)
is securely locked by pulling on it.
The keyless chuck with SDS Plus
adapter exhibits some radial play
for technical reasons.
4. Rotate the keyless chuck (17)
counter-clockwise, until the drill
chuck aperture is large enough to
accommodate the tool.
5. Push the tool as far as possible
into the keyless chuck (17).
6. Rotate the chuck clockwise to
clamp the tool firmly.
Removing tools with hexa-
gonal and cylindrical shafts
1. To remove the tool again, rotate the key-
less chuck (1) and pull out the tool.
26
Removing the keyless
chuck
1 Pull the locking sleeve (3) backwards
and remove the keyless chuck.

Operation

Selecting the operating mode

The "drilling/impact drilling" changeover
switch ( 4) allows you to select the elec-
trical tool operating mode.
Only change the operating mode
when the electrical tool is switched
on! The electrical tool may be da-
maged otherwise.
The "impact drilling" opera-
ting mode may only be used
if the keyless chuck is not at-
tached!
Unlock the changeover switch (
pushing the retaining knob (
Turn the "drilling/impact drilling" changeo-
ver switch ( 4) into the desired position.
The retaining knob (
into place once the final position has been
reached.
Impact drilling =
striking mechanism ON
Drilling/screwing =
striking mechanism OFF

Set the direction of rotation

You can select the direction of rotation
with the direction switch (
and anticlockwise direction) and secure
the device against accidental start up.
4) by
5).
5) will audibly lock
7) (clockwise