Technical Data; General Safety Instructions For Compressed Air Tools - Parkside PABK 60 A1 Betriebsanleitung

Note: This package also includes six different col-
ours of highly concentrated, water-soluble paints in
plastic containers as well as a beaker of thinner
(transparent). These are referred to as „consuma-
bles" in the following.

Technical data

Output power:
Theoretical suction capacity: max. 40 l / min
Operating pressure:
Max. pressure:
Weight without accessories: 4.175 kg
Motor output
without load:
Operating voltage:
Operating mode:
Operating time 10 min:
S3 = Intermittent periodic duty not influenced by
the starting process. During a 10 min period, the
operating time must not exceed 15 % (1.5 min).
Output of
compressor speed:
Protection class:
Protection class:
Ambient temperature
during operation:
General safety instructions
for compressed air tools
Note: When used in the following text, the terms
„compressed air device" or „device" refer to the
compressed air device specified in these instructions
for use.
Basic safety measures must be
followed when using compressed air devices to
eliminate the risk of fire, electric shock and personal
injury. Be sure to read and follow the notices within
these operating instructions prior to using the device
and store them in a safe location. The manufacturer
assumes no liability for damages or personal injury
resulting from failure to follow these operating in-
structions.
96759_par_Airbrush_Set_Content_GB_IE_CY.indd 7
Introduction / General safety instructions for compressed air tool
approx. 15 l / min
max. 0.26 MPa
0.32 MPa (approx.
3 bar)
300 W
230 V∼, 50 Hz
S3 15 %
1440 min
-1
IPX 0
I /
10 °C–30 °C
Children or persons who lack the knowledge
or experience to use the device or whose phys-
ical, sensory or intellectual capacities are lim-
ited must never be allowed to use the device
without supervision or instruction by a person
responsible for their safety.
Prevent children from playing with the device.
RISK OF INJURY! Before
performing maintenance tasks, disconnect the
compressed air supply.
Only use the device in applications for which it
was designed!
Do not overload the device.
Never use hydrogen, oxygen, car-
bon dioxide or other bottled gasses
to power this tool as doing so may
result in explosion, causing severe injuries.
Maintain and clean the device regularly as
prescribed (see Chapter „Cleaning and care").
DANGER OF EXPLOSION!
Never use petrol or other flammable liquids to
clean the compressed air tool! Sparks could ig-
nite residual vapours inside the compressed air
device resulting in the compressed air device
exploding. Do not use the device in explosive
environments with flammable liquids, gasses or
dust. Never work on materials which are or could
potentially be highly flammable or explosive.
Check the device for damage before bringing
it into use. Always make sure that the device is
in perfect condition each time before use.
Remain alert at all times and always watch
what you are doing! Unexpected movement of
the device may cause hazards.
Avoid placing your body in an unnatural position.
Keep proper footing and balance at all times.
By doing this you will be in a better position to
control the compressed air device in unforeseen
circumstances.
Do not use any device if its switch is defective.
A device that can no longer be switched on
and off is dangerous and must be repaired.
Store the device out of the reach of children
when it is not in use. Do not let anyone use the
device if he or she is not familiar with it or has
not read the instructions and advice. Compressed
GB/IE/CY 7
28.04.14 09:11