Additional Safety Instructions For All Applications; Kickback And Corresponding Safety Instructions - Parkside PFBS 12 C5 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

12) If possible, use clamps to hold the
workpiece in position. Never hold
a small workpiece in one hand and
the power tool in the other while
you are using it. By clamping small
workpieces, you keep both hands free for
better control of the power tool . When
cutting round workpieces such as dowels,
rods or pipes, be aware that these can roll
away and this can cause the tool to jam and
be thrown towards you .
13) Hold the power cord away from
any rotating accessories. If you lose
control of the appliance, the cord may get
cut or caught and your hand or arm could
get caught in the rotating accessory tool .
14) Never put the power tool down
until the accessory tool has come
to a complete standstill. The rotating
accessory tool can come into contact with
the surface and cause you to lose control of
the power tool .
15) When changing accessory tools
or changing settings, tighten the
collet nut, the chuck or other fixing
elements tightly. Loose fastening
elements can shift unexpectedly and lead
to loss of control; unsecured, rotating
components will fly off violently .
16) Do not leave the power tool running
whilst carrying it. Accidental contact
between your clothing and the rotating
accessory tool could lead to physical injury .
14 GB
17) Clean the ventilation slits of your
power tool regularly. The engine fan
draws dust into the housing and a strong
accumulation of metal dust can cause
electrical hazards .
18) Do not use the power tool in the
vicinity of flammable materials.
Sparks can ignite such materials .
19) Do not use any accessory tools
which require liquid coolant. The use
of water or other liquid coolants may lead to
electric shock .
˜ Additional safety instructions
for all applications
Kickback and corresponding safety
instructions
Kickback is a sudden reaction caused when
a rotating accessory tool, e .g . grinding disc,
grinding band, wire brush, etc ., catches or jams
and leads to an abrupt stop of the rotating
accessory tool . If this happens, an uncontrolled
power tool will turn rapidly against the direction
of rotation of the accessory tool .
If, for example, a grinding disc catches or jams,
the edge of the grinding disc that is projecting
into the workpiece can get caught and break
off the grinding disc or cause a kickback . The
grinding disc can then fly in the direction of the
operator or away from him, depending on the
direction of rotation of the disc at the blockage .
This can also break grinding discs . A kickback
is caused by improper or incorrect use of the
power tool . This can be avoided by taking
proper precautions as described below .