Staple Gun Safety; Work Safety; Supplementary Safety Instructions For Compressed Air Staplers - Parkside PDT 40 D3 Originalbetriebsanleitung

WARNING!

Staple gun safety

WARNING!
► Read all safety warnings and all instruc-
tions. Failure to follow the warnings and
instructions may result in electric shock, fire
and/or serious injury.
Save all warnings and instructions for future
reference.
■ Before starting work, check the correct functioning
of the safety and triggering mechanisms as well
as firm seating of all screws and bolts.
■ Do not carry out any unauthorised modifications
to the staple gun.
■ Do not disassemble or block any parts of the
staple gun, such as the trigger lock.
■ Do not carry out any "emergency repairs" with
unsuitable materials.
■ Maintain the staple gun regularly and properly
according to the manufacturer's guidelines.
■ Avoid any weakening of or damage to the
appliance, e.g. through
–
impacts or engraving,
–
modifications not authorised by the manu-
facturer,
–
working along stencils made of hard met-
als, e.g. steel,
–
dropping onto or sliding across the floor,
–
using it as a hammer,
–
all types of violence.
■ Fasten the staple gun firmly on supports, e.g.
on a workbench.
The mounts used must be designed so that they
protect the staple gun from damage, twisting or
slipping.
■ 38 │ GB│MT

Work safety

■ Never aim an operationally ready staple gun
directly at yourself or others.
■ While working, hold the staple gun so that your
head and body cannot be injured by a possible
kickback caused by a fault in the energy supply
or hard objects in the workpiece.
■ Never trigger the staple gun into the air.
This will prevent risks caused by flying nails or
staples and excessive strain on the appliance.
■ Before transport, disconnect the staple gun from
the compressed air source, especially if you are
using ladders or working in an unusual position.
■ In the workplace, carry the appliance only
by the handle and not with your finger on the
trigger.
■ Pay attention to the working conditions. Nails/
staples can break through thin workpieces or
slide off and injure people when working on the
corners or edges of workpieces.
■ Use suitable protection equipment to protect
yourself, e.g. hearing and eye protection.
Wearing protective equipment such as a dust
mask, non-skid safety shoes, hard hat, or hearing
protection used for appropriate conditions will
reduce personal injuries depending on the type
and use of the appliance.
Supplementary safety instructions
for compressed air staplers
WARNING! RISK OF INJURY!
► Never exceed the maximum permissible
operating pressure of 8 bar.
Use a pressure reducer to adjust the working
pressure.
► Never use oxygen or other flammable gases
as an energy source.
■
Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
PDT 40 D3