Adjusting The Cut Height; Switching On And Off; Working With The Lawnmower - Parkside PRM 1800 A2 Originalbetriebsanleitung

F

Adjusting the Cut Height

Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of injury.
1. Hold the cut height adjusting lever (5)
and guide it past the indent to the de-
sired cut height setting.
2. The handle (8) may be used to help,
in order to prevent to mower rolling
away.
20 mm - Position 1
26 mm - Position 2
33 mm - Position 3
40 mm - Position 4
50 mm - Position 5
60 mm - Position 6
70 mm - Position 7
The correct height is around 25 – 40 mm
for a decorative lawn and around 30 –
60 mm for a used lawn.
A higher cut height should be se-
lected for the first cut of the season.
Observe the noise protection and
local regulations.

Switching On and Off

G
1. Insert the power cable plug into the
socket (13) on the curved handle (1).
2. To relieve the strain, form a loop with the
end of the power cable (11) and hang
this into the strain relief (12).
3. Connect the equipment to the power sup-
ply.
4. Before switching on, ensure that the
equipment is not in contact with any ob-
jects.
5. To switch on, press the start button (15)
and one of the release buttons (14) on
the U-shaped handle (1). Keep one of the
release buttons (14) constantly pressed.
6. To switch off, let the release button (14)
go.
After switching off the equ-
ipment, the blade continues to
turn for several seconds. Do
not touch the moving blade.
There is a risk of injury.
Working with the
Lawnmower
Regular mowing encourages increased foli-
ation of the grass and kills off weeds at the
same time. Therefore, not only does each
mowing increase the density of the lawn, it
also produces an evenly resilient lawn.
The first cut is to be made in around April,
at a growth height of 70 – 80 mm. In the
main vegetation period, the lawn is to be
mowed at least once a week.
• Start mowing near the socket and work
away from the socket.
• Always keep the extension cable be-
hind you and when you turn, move it to
the side that has already been mowed.
• Run the equipment at a walking pace,
in tracks that are as even as possible.
For gap-free mowing, the tracks should
always overlap by a few centimetres.
• Adjust the cut height so the equipment
is not overloaded. Otherwise, the mo-
tor may be damaged.
• On slopes, always work across the
slope. Take particular care when going
backwards and pulling the equipment.
• Clean the equipment after each use, as
described in the chapter on "Cleaning,
Maintenance and Storage".
GB
IE
31