Mounting/Removing The Grass Box; Adjusting The Cut Height; Insert/Remove Battery; Switching On And Off - Parkside PRMA 20-Li A1 Originalbetriebsanleitung

Mounting/removing the
grass box
1. To mount the grass catch box (4) lift the
impact protection (5) and mount the
grass catcher box (4).
2. Lower the collision guard (5) onto the
grass box (4) - it will keep it in place.
3. To remove the grass box (4), lift the col-
lision guard (5) and unhook the grass
box from the mounting bracket. Flap
down the collision guard to the hous-
ing (9).

Adjusting the Cut Height

There are 5 different cutting heights:
65 mm - large cutting height
55 mm - medium cutting height
45 mm - medium cutting height
35 mm - low cutting height
25 mm - low cutting height
1. Push the cutting height adjustment lever
(7) away from the unit.
2. Move the lever (7) for adjusting the cut-
ting height past the ratchet mechanism
to the desired cutting height.
The correct height is around 25 – 45 mm
for a decorative lawn and around
45 –65 mm for a used lawn.
A higher cut height should be se-
lected for the fi rst cut of the season.
Observe noise control and local
regulations.

Insert/remove battery

Switch off the device, pull the
ignition key (12) and wait for the
blades to come to a stop. There is a
risk of personal injury.
1. Lift the transparent cover (10) on the
device housing.
2. To insert the battery (11) into the de-
vice, push the battery along the guide
rail into the device. It locks into place
audibly.
3. To remove the battery (11) from the de-
vice, press the release button (11a) on
the battery and pull the battery out.

Switching On and Off

1. Place the mower on a level sur-
face.
2. Lift the transparent cover (10) on
the device housing.
3. Slide the charged battery (11)
along the guide rail into the device.
You will hear it click into place.
4. Insert the ignition key (12) in to
the opening provided.
5. Before switching on, ensure that
the equipment is not in contact
with any objects.
6. To switch on, press the release
button (15) on the handle at the
same time as pressing the start
lever (16).
7. Release the release button (15).
8. To switch off, release the start
lever (16).
After switching off the equip-
ment, the blade continues to
turn for several seconds. Do
not touch the moving blade.
There is a risk of injury.
GB IE
27