Mulch Kit (Optionally Available); Operation; Hanging On / Removing The Grass Box; Adjusting The Cut Height - Parkside PRM 1300 A1 Originalbetriebsanleitung

GB IE NI
Mulch kit
(optionally available)
The mulch kit can be bought
separately, see "Spare parts/
accessories".
Inserting the mulch kit
1. Remove the grass collection box, if
used.
2. Lift the impact protection.
3. Place the mulch kit (22) upright with
the lower edge on the mower.
4. Push the mulch kit (22) by its lower
edge and then by its upper edge into
the ejector opening.
5. Fold the impact protection (7) over the
mulch kit (22).
Removing the mulch kit
6. Grasp the mulch kit (22).
7. Pull the upper edge of the mulch kit
(22) out of the machine first.
8. Remove the mulch kit.

Operation

Hanging On / Removing
E
the Grass Box
1. To hang on the grass box (4), lift the
collision guard (7) and hang on the
grass box. Fold the collision guard
(7) onto the grass box (4). It holds the
grass box in the correct position.
2. To remove the grass box (4), lift the col-
lision guard (7) and detach the grass
box. Fold the collision guard (7) back
onto the mower housing (6).
The level gauge (
D
side of the grass box (4). The fill level indi-
cator shows the fill level of the grass collec-
tion box when the lawnmower is running.
12
CY
20) is located on the
Flap (
D
grass box (4) empty
Flap (
D
grass box (4) full

Adjusting the Cut Height

Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of injury.
The electric lawnmower can be adjusted to
the following cutting heights with three po-
sition changes of the front and rear axles:
60 mm - Tall cutting height
40 mm - Medium cutting height
20 mm - Short cutting height
Adjust the axles one by one. The same
cutting height must be set for the front and
rear axles in order to achieve an accurate
result.
1. Place the lawnmower on its side.
F
2. Grasp the wheel axle on both
sides..
3. Pull evenly on the axle and let it
snap into the desired position.
The correct height is around 20 – 40 mm
for a decorative lawn and around
40 – 60 mm for a used lawn.
A higher cut height should be se-
lected for the first cut of the season.
Observe the noise protection and
local regulations.
20) open:
20) closed: