Operation; Hanging On / Removing The Grass Box; Adjusting The Cut Height; Switching On And Of - Parkside PRM 1200 A1 Originalbetriebsanleitung

GB IE NI

Operation

Hanging On / Removing the
Grass Box
1. To hang on the grass box (4), lift the
E
collision guard (7) and hang on the
grass box. Fold the collision guard
(7) onto the grass box (4). It holds
the grass box in the correct position.
2. To remove the grass box (4),
lift the collision guard (7) and
detach the grass box. Fold the
collision guard (7) back onto the
mower housing (6).
The level gauge (
D
side of the grass catcher (4).
Flap (
D
grass catcher (4) empty
Flap (
D
grass catcher (4) full

Adjusting the Cut Height

Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of injury.
The electric lawnmower can be adjusted to
the following cutting heights with three po-
sition changes of the front and rear axles:
60 mm - Tall cutting height
40 mm - Medium cutting height
20 mm - Short cutting height
1. Place the lawnmower on its side.
F
2. Grasp the wheel axle on both
sides.
3. Pull evenly on the axle and let it
snap into the desired position.
12
CY
20) is located on the
20) open:
20) closed:
The correct height is around 20 – 40 mm
for a decorative lawn and around
40 – 60 mm for a used lawn.
A higher cut height should be se-
lected for the irst cut of the season.
Observe the noise protection and
local regulations.
Switching On and Off
1. Before switching on, ensure that
the equipment is not in contact
with any objects.
2. To switch on, press the release but-
ton (10) on the handle at the same
time as pressing the start lever (12).
Release the release button (10).
3. To switch off, release the start
lever (12).
After switching off the equipment,
the blade continues to turn for sev-
eral seconds. Do not touch the mov-
ing blade. There is a risk of injury.