Steam Ironing; Ending Ironing; Cleaning And Care - Silvercrest BL DB 1800 B2 Bedienungs- Und Sicherheitshinweise

Steam burst
You can steam the fabric through the soleplate 1
as required . To do so, press the steam button 6 .
NOTE: The temperature control 10 should be set
to to generate the steam burst .

Steam ironing

You can also set the iron to continuously give off
steam .
The temperature control 10 should be at the
highest level to produce enough steam . As
long as the product has not yet reached the set
temperature and is still heating up, the control
light 9 remains lit .
Once the set temperature has been reached, the
control light 9 goes off .
Set the steam control 4 to the desired steam
amount . The steam control has 3 positions:
No
steam
NOTE:
Continuous steam ironing is only possible when
the iron is held horizontally . If you hold the iron
vertically or set it down, this interrupts steam
operation .
Steam ironing finished: Set the steam control 4
to the (no steam) position .
22 GB/IE
Medium Maximum
steam steam
˜ Ending ironing
1 . Turn the temperature control 10 counter-clockwise
all the way to MIN .
2 . Set the steam control 4 to the
position . Set down the product with the base 8
on an even, stable surface .
3 . Disconnect the power plug 7 from the socket-
outlet .
4 . Let the product cool (this take approximately
15 minutes) . Do not leave the product
unattended while it is still hot .
5 . To prevent limescale build-up, empty the water
tank after each use . To do so, open the lid of the
3 . Empty the water tank via the
fill opening
fill opening
by holding the iron upside down
over a sink .
˜ Cleaning and care
DANGER! Risk of electric shock! Always
disconnect the plug 7 from the socket-outlet
before cleaning the product .
m
WARNING! Do not immerse the product's
electrical components in water or other liquids .
Never hold the product under running water .
Wipe down the product with a slightly damp
cloth .
Do not let any water or other liquids enter the
product interior .
Do not use any abrasive, aggressive cleaners or
hard brushes to clean the product .
Clean the soleplate 1 using a damp cloth and a
mild, non-scouring detergent .
Let all parts dry completely after cleaning .
(no steam)